Go back to the wall where you are installing your thermostat and continue to “Installing
Your New Thermostat” on the next page.
Installing Your New Thermostat
You will need: Level, pencil, drill, and a drill bit
18. position wall plate
Pull open the wall plate that was included with your new thermostat. Insert the bundle of wires through the back of the wall plate.
Make sure at least 1/4-inch of each wire is exposed for easy insertion into the wire terminals.
19. Insert recommended wall anchors
It is recommended that you use the wall anchors included in the box to mount your thermostat.
You can use the wall plate to mark where you want to place the wall anchors.
a) Level the wall plate
b) Mark the location of the wall anchors using a pencil
c) Remove the wall plate
d) Drill anchor holes.
If your box contains red anchors, drill 7/32” holes.
If your box contains yellow anchors, drill 3/16” holes.
e) Insert the wall anchors
f) Make sure the anchors are flush with the wall
g) Reposition the wall plate on the wall
To Next Page
Loading...
