Honeywell 2MLL-PMEB - 9.3 Operation Sequence of P2 P

Chapter 9 P2P
3 Pnet I/F Module 2MLL-PSRA, 2MLL-PMEA, 2MLL-PMEB User’s Guide R220
Honeywell January 2019
9.3 Operation Sequence of P2P
Operation sequence of P2P
No.
S/ W applied
Operation
Details
1
N Configurator
Execute Configuration tool
Execute N Configurator
2
Set Network Configuration
Refer to Chapter 7 N Configurator Setting (2MLL-
PMEB/C)
3
Connect to
communication port
Refer to Chapter 7 N Configurator Setting (2MLL-
PMEB/C)
4
Download Network
Configuration
Refer to Chapter 7 N Configurator Setting (2MLL-
PMEB/C)
5
SoftMaster
SoftMaster execution
Execute installed SoftMaster
6
Make new file
Project  New project
Setting project name and type
7
Set SoftMaster connection
Select applicable connection driver through
SoftMaster  Online  Connection settings
8
Connect to SoftMaster
SoftMaster  Online  Connect
9
IO Information Read
SoftMaster  Online  Diagnosis  I/O Information
10
Define P2P project
Specify “P2P” on the SoftMaster screen
11
Add P2P
Right click the PLC  Add item  Communication
module setting and set the communication module,
base, slot, P2P number
12
P2P Block Setting
Double-click the cell on the “P2P” screen
1) For Write: specify Read area (CPU area)
2) For Read: specify Save area (CPU area)
13
P2P Parameters Write
Online  Write: check applicable P2P and write
14
P2P Enable
Online  Communication module setting  Enable
Link: enable applicable P2P
[Table 9.3.1] Operation sequence of P2P