Chapter 10 Program Example
3 Pnet I/F Module 2MLL-PSRA, 2MLL-PMEA, 2MLL-PMEB User’s Guide R220
Honeywell January 2019
There are 2 ways to set the slave module. It is Manual setting and Automatic setting.
First of all, Manual setting is as shown below.
Click the Slave setting icon (It is indicated red circle), the screen is changed as shown below [Figure
10.1.4]. If there is not a slave module to register in dotted line as shown below, GSD file should be copied
in file directory as shown below [Figure 10.1.5]
[Figure 10.1.4 Slave module setting (Manual setting)
[Figure 10.1.5] GSD file directory
Station address 1 of slave module is selected as shown above [Figure 10.1.4]. After station address set to
1 as shown below, click ‘OK’. Slave module setting is as shown below. Double-click the applicable module,
Slave configuration is displayed. In the slave configuration, it displays the status of slave module GSD file
applied and status of Input/Output appended currently.
To Next Page
Loading...
