Chapter 10 Program Example
39 Pnet I/F Module 2MLL-PSRA, 2MLL-PMEA, 2MLL-PMEB User’s Guide R220
Honeywell January 2019
[Figure 10.3.18] Config. Upload (Dnet, Pnet) menu
After N Configurator setting file is uploaded, setting information is displayed in block window as shown
below. Double click the applicable index to set the address. Set %MW0 to read area for station 4, %MW200
to save area for station 2.
[Figure 10.3.19] High-speed link block setting
After finish the setting, setting information is downloaded in PLC. Select [Online] – [Write] (standard settings,
High-speed link, P2P). Here, Check High-speed link to download and click ‘OK’.
To Next Page
Loading...
