Honeywell 2MLL-PMEB - Page 40

Chapter 5 Communication Program
11 Pnet I/F Module 2MLL-PSRA, 2MLL-PMEA, 2MLL-PMEB User’s Guide R240
Honeywell January 2019
5.2.4 P2P Parameter Setting
(1) The screen after communication module setting is as follow
[Figure 5.2.14] The screen after communication module setting
(2) P2P parameter setting
Item
Description
P2P function
Write, read, diagnostic
Condition flag
Condition flag
Data type
*1
Data type
No. of variable
*1
No. of variable
Destination station
Check destination station
No. of destination
station
Destination station
Setting
Read area
Sending data area
Save area
Save area of receiving data
Data size
Sending/Receiving data size
*1 isn’t setting area.
[Table 5.2.15] P2P block setting