Honeywell 2MLL-PMEC - Page 114

Chapter 9 P2P
8 Pnet I/F Module 2MLL-PSRA, 2MLL-PMEA, 2MLL-PMEB User’s Guide R220
Honeywell January 2019
9) Write the P2P parameter
Click “Online”  “Write” in SoftMaster, check the applicable High-speed link and then click [OK].
[Figure 9.4.6] Screen of Write the parameter
10) Enable of P2P
Click “Online”  “Communication module setting”  “Enable Link” in SoftMaster, check the
applicable P2P and then click [Write]. If P2P is enabled, on the module’s LED display P2P LED will
be on, when P2P starts.
[Figure 9.4.7] Screen of Link Enable