Chapter 5 Communication Program
7 Pnet I/F Module 2MLL-PSRA, 2MLL-PMEA, 2MLL-PMEB User’s Guide R240
Honeywell January 2019
2) Registration in the online status
Connect to the ML200 CPU module. After connection, if you select [Online]-[Diagnosis]-[I/O
Information…], then click “I/O Sync], it searches all communication module and register them
automatically
* PLC should be STOP status for I/O Sync
[Figure 5.2.6] Read IO Information
In case Pnet is installed at the base 0, slot 10, it searches and registers as follows.
[Figure 5.2.7] Basic setting and Communication module Settings screen
To Next Page
Loading...
