Honeywell 3800gPDF - Hand Held Decoding Linear Imager - Interleaved 2 of 5 Message Length

7 - 9
When Check Digit is set to Validate and Transmit, the imager only reads Inter-
leaved 2 of 5 bar codes printed with a check digit, and will transmit this digit at
the end of the scanned data.
Default = No Check Digit.
Interleaved 2 of 5 Message Length
Scan the bar codes below to change the message length. Refer to Message
Length on page 7-2 for additional information. Minimum and Maximum
lengths = 2-80. Minimum Default = 4, Maximum Default = 80.
Validate, but Don’t Transmit
* No Check Digit
Validate and Transmit
Minimum Message Length
Maximum Message Length