Honeywell 5010

1
Chapter 1 - Getting Started
Introduction ................................................................. 1-1
About This Manual ...................................................... 1-1
Unpacking the Engine ................................................. 1-1
OEM Engine Models ................................................... 1-2
Connecting the Development Engine to the PC.......... 1-3
Chapter 2 - Getting Connected
Plug and Play .............................................................. 2-1
RS-232 .................................................................. 2-1
IBM SurePos ......................................................... 2-1
USB HID................................................................ 2-2
USB COM Port Emulation..................................... 2-2
Chapter 3 - Terminal Interfaces
Terminal ID.................................................................. 3-1
Supported Terminals................................................... 3-1
RS-232 Baud Rate ................................................ 3-2
RS-232 Word Length: Data Bits, Stop Bits,
and Parity .............................................................. 3-3
RS-232 Receiver Time-Out................................... 3-4
RS-232 Handshaking ............................................ 3-4
TTL Level 232 Interface ........................................ 3-5
Chapter 4 - Output
Image VGA.................................................................. 4-1
Table of Contents