– 36 –
Arming All Protection
(With Entry Delay OFF)
Using the 4 MAXIMUM Key
Use this key when the premises will be vacant for extended periods of time
such as vacations, etc., or when no one will be moving through protected
interior areas.
When armed in MAXIMUM mode, the system will sound an alarm if a
protected door or window is opened, or if any movement is detected inside the
premises. You may leave through the entrance door during the exit delay
period without causing an alarm, but an alarm will be sounded as soon as
someone reenters.
Close all perimeter windows and doors before arming (see
CHECKING FOR OPEN ZONES section).
MAXIMUM
1. Enter your security code and press 4 .
2.
ARMED *MAXIMUM*
YOU MAY EXIT NOW
The keypad will beep twice and will display the
armed message.
Note: The "YOU MAY EXIT NOW" portion of
the message disappears when exit delay
expires.
NOTE: Failure to close an open exit route zone before the exit delay time
ends may result in that zone being automatically bypassed or in alarm,
depending on how your system was programmed by your installer Consult
your installer for the configuration of your system.
To Next Page
Loading...
Need help?
General
