On the wall
You can also mount the camera directly to the wall without the stand.
Operation
Remove/replace the stand
The stand is connected to the camera by a magnet. If you want to remove the stand to hang the camera on the wall or replace the SD card,
simply pull the standoff of the camera. To replace it, just snap it back on the camera.
Honeywell Home app experience
When you launch the application, your Home screen is displayed. All of your devices (cameras, thermostats, water leak detectors, etc.) are
displayed. Select a camera from the list to view live video from that camera
Testing smoke/CO alarm detection
If your smoke or carbon monoxide alarm goes off and your camera is on, it will send you an alert that a smoke or CO alarm has been
detected. To test this feature, press and hold the Test button on your smoke/CO detector for at least 5 seconds or 3 cycles of the detector’s
alarm. A shorter test might not trigger a sound event.
Camera overview
To Next Page
Loading...
Need help?
General
