4. The camera LED turns purple and the camera beeps
Connect to Wi-Fi
NOTE: Be sure you are on the same Wi-Fi network you wish to connect your camera to.
Choose your Wi-Fi network from the Tap NEXT.
Enter your Wi-Fi password, if Tap DONE.
NOTE: The camera will beep during some steps in this process.
Wi-Fi connection LEDs
During Wi-Fi connection, the LED indicates the following
LED Camera state
Blinking Green Connecting to Wi-Fi network.
Solid Green Connected to Wi-Fi network.
Solid Red (for 2 seconds) Connection failed. LED will then turn solid purple.
Solid Purple QR Code scan complete. Go to “Connect to Wi-Fi” on page 3.
Blinking Blue
The camera has lost Bluetooth connection. Unplug the camera and plug it back in. See “Connect
the power cord” on page 2 for instructions.
Options
Choose your Geofencing and Membership options (if you skip them you can change them easily later).
Placement
Withstand
Place the camera in the desired location for viewing and recording.
To Next Page
Loading...
Need help?
General
