Connecting the CF3680 to a Host
By default, the CF3680 is in USB PC Keyboard interface.
1. Connect a standard USB cable (standard USB-A to USB-B)
to the CF3680 and to the USB port on the host.
2. Power-up the host.
3. Verify that the CF3680 is on by presenting a bar code in
front of the scan window. The white LED should turn on and
read the bar code.
Note: The CF3680 does not beep to indicate a good read unless
this has been setup by the user with the user feedback pins.
See the CF3680 Installation Guide for more details
(available from your local Honeywell OEM representative).
To Next Page
Loading...
