8 69-0865
9 69-0865
5. Press and hold +CHAUD or +FROID key until the
display shows the desired heating temperature.
6. Repeat steps 1-5 for the remaining periods—SOR-
TIE, RETOUR and CHOUCHER—as desired.
You may cancel the SORTIE, RETOUR or CHOUCHER
program by holding down the period key (SORTIE,
CHOUCHER and RETOUR) until the time and tempera-
ture disappear from the display.
NOTE: If the display flashes while you are holding down
the +CHAUD or +FROID key, you have reached the
setting limit. For the automatic changeover models,
the heating temperature must be at least two degrees
below the cooling temperature. For example, if the
cooling setting is 24° C, the maximum heating setting
is 22° C. To set a higher heating temperature, you
must first raise the cooling setting.
To set the Saturday and Sunday schedules, use the
same procedure as for weekdays.
Program Schedule
Weekdays Start Time Heating Temperature Cooling Temperature
RÉVEIL
SORTIE
RETOUR
CHOUCHER
Saturday
RÉVEIL
SORTIE
RETOUR
CHOUCHER
Sunday
RÉVEIL
SORTIE
RETOUR
CHOUCHER
1 1
1
Heating and cooling temperatures must be at least 2° C apart.
Set Current Day and Time
1. To set the day, press and release RÉGLER JOUR/
HEURE key.
2. Press and hold JOUR key until the current day ap-
pears in the display.
3. To set the time, press and release RÉGLER JOUR/
HEURE key.
4. Press and hold AVANCER or RECULER key until
the current time appears in the display.
5. Press ACTIVER PROGRAMME key.
Heating Program
1. Press and release RÉVEIL key.
, the pre-
programmed time and temperature appear on the display.
2. Press and hold the JOUR key until the current day
appears on the display. If the display reads cool, press
and release MODE CHAUFF. REFROID. key to switch to
heat.
3. Press and hold JOUR key until LU (or the desired
day) is indicated.
4. Press and hold AVANCER or RECULER key until
the display shows the time you want the temperature to
be at the comfort setting.
To Next Page
Loading...
Need help?
General
