Honeywell CM907 User Manual

3
This section shows you how to setup and run the thermostat in 3 simple steps:
STEP 1: Installing the Batteries
Note: Please follow the instructions in this section only if the thermostat screen is
blank (no symbols or digits are displayed). If the screen displays some information
move on to STEP 2: Setting the Date and Time.
To install the Batteries:
a. Lift up the front cover of the thermostat
to reveal the battery cover and product
controls.
b. Remove the battery cover by pressing
down and sliding out.
c. Insert the 2 x AA LR6 Alkaline Batteries
supplied with the thermostat, ensuring
the correct orientation (see ‘Controls
Layout’ on page 2).
d. After a short pause the thermostat will
display information on the screen and
is now ready for use.
e. Replace the battery cover by sliding
it rmly back into the front of the
thermostat.
GETTING STARTED WITH THE CM907
PLEASE RESPECT YOUR ENVIRONMENT!
Take care to dispose of used batteries carefully.

Honeywell CM907 Specifications

General

Programming	7-day programmable
Temperature Control	Electronic
Power Source	Battery
Mounting	Wall Mounted
Control Mode	On/Off
Switching Action	SPDT (Single Pole Double Throw)
Temperature Setting Range	5°C to 35°C
Power Supply	2 x AA Alkaline Batteries
Holiday Mode	Yes
Optimum Start	Yes
Accuracy	±0.5°C
Battery Backup	Yes
Type	Programmable Thermostat
Display	LCD
Temperature Display Range	0°C to 40°C
Number of Time Periods	6 per Day
Frost Protection	Yes
Voltage	230V AC
Switching Current	8A Resistive, 3A Inductive