25
SMB System C Handling
• The Safety Post can be set lower by removing
of pin 100122 and removing Cloxy and push-
ing the post down.
• When using Cast-In Sleeves, the length of the
Sleeve must be set so that the Safety Post or
the Safety Post Extender is inserted at least
100 mm into the concrete.
• The Plastic Plug in the bottom of the Cast-In
Sleeve reduces the insertion depth and must
be taken into consideration when calculating
the sleeve length.
• When inserted in Pre-Cast Attachments,
check that the Safety Post or the Safety Post
Extender is inserted at least 100 mm into the
attachment metal sleeve, unless stated other-
wise in product specific information.
Steel Mesh Barrier Holder 3222
1. Thread the Steel Mesh Barrier Holder onto the
top section of the Safety Post.
To Next Page
Loading...
