Honeywell COMBISAFE - Handling - Toeboard Holder; Toeboard Holder 4110 Fitting

34
Handling SMB System C
ToeBoard Holder 4110
1. Place the toeboard against the
attachment or Safety Post on the
inside of the edge protection.
NOTE
Remember that the toeboard must be at least 150 mm high.
2. Thread the Toeboard Holder onto the
Safety Post and down over the toeboard
ensuring the Toeboard Holder locks the
toeboard onto the attachment or Safety
Post.
The Toeboard Holder can be used in
two different positions to secure a
single toeboard or both toeboards at an
overlap.
I. Turn the Toeboard Holder using the
short side inwards when there is one
toeboard, e. g. an end.
II. Turn the Toeboard Holder using the
long side inwards when there are two
toeboards, e. g. a joint.
[mm]
>1
50
1974_819