Honeywell CT3500 - Page 16

69-1199—4 16
The setpoint temperature range is 40°F to 90°F (5°C to 2°C) for heating and 45°F to 99°F (7°C to 37°C) for cooling.
q Press to switch between heating and cooling setpoints.
NOTE: Program times are the same for heating and cooling.
q Press or until the display shows the desired temperature setpoint.
q Press , or and repeat these steps for each time period. Your weekday is now programmed.
Program Saturday and Sunday
Repeat each step in Program Weekdays for Saturday and Sunday.
q Press when the entire week is programmed.
Clear a Program Period
NOTE: Wake cannot be cleared.
q Press , , or for the program period you want to clear.
q Press until the desired day displays (Mon-Fri Sat; Sun).
q Press and hold the , , or for approximately 3 seconds until the time and temperature clear.
q Repeat the above steps for each period to be cleared.
q Press .
Heat/Cool
Settings
Leave
Return
Sleep
Run
Program
Leave
Return
Sleep
Day
Leave
Return
Sleep
Run
Program