What to do if my Honeywell Thermostat has no heat?
First, ensure that the power is on at the main service panel. The heater should start warming up within two minutes. If it doesn't, contact a qualified electrician to inspect the thermostat and heater. Also, with the power to the circuit OFF, tighten all wiring connections and repair any frayed or broken wires.
Why is there no heat from my Honeywell CT410B?
If your Honeywell Thermostat is not producing heat, first, ensure that the main service panel has power. Then, turn the temperature setting knob fully clockwise. If the issue persists, with the power to the circuit OFF, check and tighten all wiring connections, repairing any frayed or broken wires. If the problem continues, it is recommended to contact a qualified electrician for assistance.
What to do if my Honeywell CT410B setting and thermometer reading disagree?
Contact an electrician to change the location of the thermostat. The thermostat should be about 5 ft (1.5m) above the floor and on an inside wall, because it might be affected by drafts or radiant heat.
What to do if my Honeywell Thermostat heater never turns off?
If your Honeywell Thermostat's heater never turns off, try turning the temperature setting knob fully counterclockwise. If this does not resolve the issue, turn off the power at the main service panel and contact a qualified electrician.
General| Control Type | Manual |
|---|---|
| Power Source | Line Voltage |
| Stages | Single Stage |
| Mounting | Wall |
| Temperature Range | 50°F to 90°F |
| Application | Electric Baseboard Heaters |
| Switch Action | SPST |
To Next Page
