DC1000 Series Program Configuration Guide
Operation Mode Configuration 1
Configuration 2 Program Mode
Set Up Mode
(1)
(3)
(2)
(2)
(3)
How to move from a MODE to another
(1) Press ‘SET’ key for 5 seconds, it grants access to ‘Configuration 1’ mode or return to
‘Operation’ mode from ‘Configuration 1’ mode.
(2) Press ‘SHIFT’ key for 5 seconds while pressing ‘SET’ key first, it grants access to
‘Configuration 2’ mode or return to ‘Operation’ mode.
(3) All parameters related to program configuration will be displayed next to parameters in
‘Operation’ mode. (* These parameters will be shown in program model only)
CAUTION
DO NOT access to ‘Set Up’ mode without instruction from techical assistant.
To Next Page
