Honeywell DH70W User Manual

17
ERROR CODE GUIDE
EN
ERROR
CODE
POSSIBLE CAUSE DESCRIPTION
“30”
Humidity Sensor
Failure
(Below 30%RH)
If “30” appears, it means the room’s relative humidity exceeds the
lowest 30%RH level and the unit will pause operation. You can
switch the unit ON again when the relative humidity reaches a
level above 30% for 2 hours or more.
If the “30” appears again, please contact the Customer Service
Center.
“90”
Humidity Sensor
Failure
(over 90%RH)
If “90” appears, it means the room’s relative humidity exceeds the
highest 90%RH level and the unit will pause operation. You can
switch the unit ON again when the relative humidity reaches a
level below 90% for 2 hours or more.
If the “90” appears again, please contact the Customer Service
Center.
“Lo”
Temperature Sensor
Failure
(below 32°F / 0°C)
If “Lo” appears, it means the ambient room temperature is too
cold, below 32°F (0°C) and so operation will be paused. You can
switch ON the unit again when the ambient temperature warms
up to 41°F (5°C) or higher for 2 hours or more.
If “Lo” appears again, please contact the Customer Service Center.
“Hi”
Temperature Sensor
Failure
(over 122°F / 50°C)
If “Hi” appears, it means the ambient room temperature is too hot,
or above 122°F (50°C) and so operation will be paused. Move
the unit away from any heat source that may be causing this hot
temperature. You can switch ON the unit again when the ambient
temperature cools down to 89°F (32°C) or lower for 2 hours or
more.
If “Hi” appears again, please contact the Customer Service Center.
Electrical products should be properly disposed of.
Please recycle where facilities exist.
Check with your local authority or retailer for recycling.

Honeywell DH70W Specifications

General

Brand	Honeywell
Model	DH70W
Category	Dehumidifier
Language	English