N5600 Green Aiming Beam
Linear Bar Code
2D Matrix Symbol
Resetting the Terminal
There are three types of system resets: a soft reset, a hard reset, or a factory
reset. The soft and hard resets preserve all data stored in the file system.
Contact a Honeywell technical support representative for more information on
how to perform a factory reset.
Soft Reset (Warm Boot)
A soft reset re-boots the device and preserves any objects created in RAM.
You would perform a soft reset when: the terminal fails to respond, after
installing some software applications, or after making changes to certain
system settings, such as network cards.
1. Press and hold the BLUE + END keys for approximately 5 seconds.
2. The general notification LED flashes orange then green for
approximately 3 seconds as the terminal resets.
3. When the reset is complete, the Home screen displays.
To Next Page
Loading...
