3
Step 1: Install the Main Battery Pack
Use only the Li-ion battery packs provided by Honeywell. Use of any battery not sold/
manufactured by Honeywell may result in damage not covered by the warranty.
Step 2: Charge the Batteries
The power supply consists of two types of battery power: the
main battery pack installed in the back panel and the backup
battery located inside the terminal.
The main battery powers the terminal and charges the internal
backup battery. The internal backup battery maintains the data
stored in RAM memory and keeps the system clock running for
up to 30 minutes when the main battery is completely
discharged or removed.
Terminals are shipped with both batteries completely
discharged. Charge the main battery pack for a minimum
of 4.5 hours before initial use in the terminal!
Connect the terminal to a Dolphin 9900 powered charging
peripheral - see page 4.
Use only the peripherals, power cables, and power adapters from
Honeywell. Use of peripherals, power cables, or power adapters not sold/manufactured
by Honeywell may cause damage not covered by the warranty.
To Next Page
Loading...
