4
Step 3: Boot the Terminal
The terminal begins booting as soon as power is applied and runs by itself. Do
NOT press any keys or interrupt the boot process. Only tap the screen when
prompted.
When the boot process is complete, the Today screen appears and the terminal
is ready for use.
Note: Because the Today screen appears a number of times during the boot
process, wait a few seconds before tapping anything on the Today
screen.
Resetting the Terminal
Peripherals and Accessories
Soft Reset: On the 56-key keyboard, press and hold the CTRL + SFT
keys for approximately five seconds.
On the 43-key keyboard, press and hold the CTRL + NUM
keys for approximately five seconds.
A soft reset re-boots the terminal without erasing RAM data.
Hard Reset: Press and hold the CTRL + ESC keys for approximately 5
seconds.
A hard reset erases all data and applications stored in RAM
memory and re-initializes the terminal.
Dolphin HomeBase
™
Device
Charging/communications cradle with auxiliary battery
well. Data transfers via RS-232 serial or USB ports.
Dolphin MobileBase
™
Device
Mobile charging/communication cradle. RS-232 serial
transfers data and powers out at 5 volts.
Dolphin
QuadCharger
™
Device
Four-slot battery charger that charges four Li-ion
batteries in less than five hours. One slot doubles as a
battery analyzer.
Dolphin Mobile Charger
Charges a Dolphin terminal by plugging into a vehicle
cigarette lighter/power port.
Dolphin Net Base Four-slot charging/communication cradle designed for
Ethernet-based communications.
Dolphin ChargeBase Four-slot charging cradle that stores, powers, and
charges a terminal in each slot.
Dolphin Cable Kits USB or serial cables that charge and communicate with
the terminal directly, without a cradle.
To Next Page
Loading...
