5
Install the Main Battery Pack
The 99EX is shipped with the battery packaged separate
from the unit. Follow the steps below to install the main
battery. For information on how to remove the battery, see
page 6.
1. Release the hook securing the hand strap to the back
panel of the terminal.
2. Remove the battery door by lifting up the latches near
the base of the battery door.
3. Insert the battery into the battery well.
4. Replace the battery door. Apply pressure to engage
the door latch. The battery door must be installed
prior to powering the unit.
5. Reattach the hand strap.
6. Connect the terminal to one of the 99EX series
charging peripherals to charge the main battery pack.
We recommend use of Honeywell Li-poly or Li-ion
battery packs. Use of any non-Honeywell battery may
result in damage not covered by the warranty.
99EX_QS.book Page 5 Friday, March 4, 2011 2:42 PM
To Next Page
Loading...
