EasyManua.ls Logo

Honeywell DT7500SN V-Plex DUAL TEC User Manual

Honeywell DT7500SN V-Plex DUAL TEC
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
DT7500SN V-Plex
TM
DUAL TEC
Motion Sensor - Installation Instructions
W
T
T
V-
V+
OPEN / OUVERTURE / APERTURA / APERTURA / OPEN
LOCATION / EMPLACEMENT / POSIZIONAMENTO / LOCALIZACIÓN / LOCATION
MOUNT / INSTALLATION / MONTAGGIO / MONTAJE / MOUNT
3
Range Adjustment
Réglage de la portée hyper
Regolazione della portata
Ajuste del rango de detección
Range Adjustment
5
2.1 - 2.4 m
(7 - 8 ft)
1
6
2
WIRE / CABLAGE / COLLEGAMENTO / CABLEADO / WIRE
IDENTIFY COMPONENTS AND SELECT APPROPRIATE SETTINGS / IDENTIFICATION DES COMPOSANTS ET SÉLECTION DES PARAMÈTRES APPROPRIÉS / IDENTIFICARE I COMPONENTI
E SELEZIONARE LE IMPOSTAZIONI APPROPRIATE / IDENTIFICAR LOS COMPONENTES Y SELECCIONAR LA CONFIGURACIÓN ADECUADA / IDENTIFY COMPONENTS AND SELECT
APPROPRIATE SETTINGS
1
Polling Loop
9 - 13VDC
SMB-10T
TAMPER
24 VDC,
10mA
0.3-1.3mm
2
(22-16 AWG)
Cover Tamper Switch
Contact AP du capot
Interruttore tamper sul
coperchio
Tamper de la cubierta
Cover Tamper Switch
3
2
Rear Tamper Breakaway Tab
Rear Tamper Breakaway Tab
Rear Tamper Breakaway Tab
Rear Tamper Breakaway Tab
Rear Tamper Breakaway Tab
W
With SMB10T
With SMB10T
With SMB10T
With SMB10T
With SMB10T
With SMB10T
ON
OFF
1
234
5
25%
50%
75%
100%
T
T
+
-
W
ON
OFF
1
234
5
Pulse Count 2
Low Sensitivity
LED Disabled
Microwave Walk Test OFF
Anti-Mask OFF
Pulse Count 1
High Sensitivity
LED Enabled
Microwave Walk Test ON
Anti-Mask ON
LED
REPLACE CIRCUIT BOARD / REMISE EN PLACE DU PCB /
RIPOSIZIONARE IL CIRCUITO / VOLVER A COLOCAR LA
PLACA DE CIRCUITO IMPRESO / REPLACE CIRCUIT
BOARD
4
If installed with a Smart V-Plex
TM
Panel:
The sensor will not transmit or indicate intrusion alarms
when the panel is disarmed; in the armed state, the sensor
will respond to all communications to or with the host panel.
If installed with a Standard V-Plex
TM
Panel:
The sensor will respond to all communications with the
host panel armed or disarmed.
ON
OFF
1
234
5
Pulse Count 2
Low Sensitivity
LED Disabled
Microwave Walk Test OFF
Anti-Mask OFF
Pulse Count 1
High Sensitivity
LED Enabled
Microwave Walk Test ON
Anti-Mask ON
<FR> If installed with a Smart V-Plex
TM
Panel: The sensor will not
transmit or indicate intrusion alarms when the panel is disarmed;
in the armed state, the sensor will respond to all communications
to or with the host panel.
If installed with a Standard V-Plex
TM
Panel: The sensor will
respond to all communications with the host panel, armed or
disarmed.
Use these holes when
mounting to a standard
U.S. electrical junction box
ON
OFF
1
2
Lowest Sensitivity: 3 - 5 Steps; Up to 45 kg (100 lb) Pet Immunity
Lowest Sensitivity: 3 - 5 Steps; Up to 45 kg (100 lb) Pet Immunity
Lowest Sensitivity: 3 - 5 Steps; Up to 45 kg (100 lb) Pet Immunity
Lowest Sensitivity: 3 - 5 Steps; Up to 45 kg (100 lb) Pet Immunity
Lowest Sensitivity: 3 - 5 Steps; Up to 45 kg (100 lb) Pet Immunity
ON
OFF
1
2
Low Sensitivity: 2 - 4 Steps; Up to 23 kg (50 lb) Pet Immunity
Low Sensitivity: 2 - 4 Steps; Up to 23 kg (50 lb) Pet Immunity
Low Sensitivity: 2 - 4 Steps; Up to 23 kg (50 lb) Pet Immunity
Low Sensitivity: 2 - 4 Steps; Up to 23 kg (50 lb) Pet Immunity
Low Sensitivity: 2 - 4 Steps; Up to 23 kg (50 lb) Pet Immunity
ON
OFF
1
2
Medium Sensitivity: 1 - 3 Steps; No Pet Immunity
Medium Sensitivity: 1 - 3 Steps; No Pet Immunity
Medium Sensitivity: 1 - 3 Steps; No Pet Immunity
Medium Sensitivity: 1 - 3 Steps; No Pet Immunity
Medium Sensitivity: 1 - 3 Steps; No Pet Immunity
ON
OFF
1
2
High Sensitivity: 1 - 2 Steps; No Pet Immunity
High Sensitivity: 1 - 2 Steps; No Pet Immunity
High Sensitivity: 1 - 2 Steps; No Pet Immunity
High Sensitivity: 1 - 2 Steps; No Pet Immunity
High Sensitivity: 1 - 2 Steps; No Pet Immunity
Look-Down Mask (install as shown when using Pet Immune Lens)
Look-Down Mask (install as shown when using Pet Immune Lens)
Look-Down Mask (install as shown when using Pet Immune Lens)
Look-Down Mask (install as shown when using Pet Immune Lens)
Look-Down Mask (install as shown when using Pet Immune Lens)
a
ON
OFF
1
234
5
Pulse Count 2
Low Sensitivity
LED Disabled
Microwave Walk Test OFF
Anti-Mask OFF
Pulse Count 1
High Sensitivity
LED Enabled
Microwave Walk Test ON
Anti-Mask ON
<IT> If installed with a Smart V-Plex
TM
Panel: The sensor will not
transmit or indicate intrusion alarms when the panel is disarmed;
in the armed state, the sensor will respond to all communications
to or with the host panel.
If installed with a Standard V-Plex
TM
Panel: The sensor will
respond to all communications with the host panel, armed or
disarmed.
ON
OFF
1
234
5
Pulse Count 2
Low Sensitivity
LED Disabled
Microwave Walk Test OFF
Anti-Mask OFF
Pulse Count 1
High Sensitivity
LED Enabled
Microwave Walk Test ON
Anti-Mask ON
<ES> If installed with a Smart V-Plex
TM
Panel: The sensor will not
transmit or indicate intrusion alarms when the panel is disarmed;
in the armed state, the sensor will respond to all communications
to or with the host panel.
If installed with a Standard V-Plex
TM
Panel: The sensor will
respond to all communications with the host panel, armed or
disarmed.
ON
OFF
1
234
5
Pulse Count 2
Low Sensitivity
LED Disabled
Microwave Walk Test OFF
Anti-Mask OFF
Pulse Count 1
High Sensitivity
LED Enabled
Microwave Walk Test ON
Anti-Mask ON
<PT> If installed with a Smart V-Plex
TM
Panel: The sensor will not
transmit or indicate intrusion alarms when the panel is disarmed;
in the armed state, the sensor will respond to all communications
to or with the host panel.
If installed with a Standard V-Plex
TM
Panel: The sensor will
respond to all communications with the host panel, armed or
disarmed.
Wide Angle Lens (installed)
Wide Angle Lens (installed)
Wide Angle Lens (installed)
Wide Angle Lens (installed)
Wide Angle Lens (installed)
Pet Immune Lens (included)
Pet Immune Lens (included)
Pet Immune Lens (included)
Pet Immune Lens (included)
Pet Immune Lens (included)
Question and Answer IconNeed help?

Do you have a question about the Honeywell DT7500SN V-Plex DUAL TEC and is the answer not in the manual?

Honeywell DT7500SN V-Plex DUAL TEC Specifications

General IconGeneral
TypeMotion Detector
Detection MethodPassive Infrared (PIR) and Microwave
Coverage Area50 ft x 50 ft (15.2 m x 15.2 m)
Tamper ProtectionYes
Housing MaterialHigh-impact ABS plastic
MountingWall or corner
TechnologyDUAL TEC
Relay Contact RatingN/A (V-Plex communication)

Summary

Mounting and Location

Mount Installation

Instructions for physically mounting the sensor unit to a surface or junction box.

Replace Circuit Board

Guidance on how to replace the sensor's internal circuit board.

Location Selection

Recommendations for choosing the optimal installation location for the sensor.

Component Identification and Settings

Identify Components

Identifying key components and features of the motion sensor.

Sensitivity and Pulse Count Settings

Configuring sensitivity levels and pulse count for detection.

Pet Immunity Setup

Instructions for setting up pet immunity functionality.

Look-Down Mask Installation

Instructions for installing a mask to block downward detection zones.

Sensor Programming and Testing

Program Sensor Serial Number ID

Procedure for entering the sensor's serial number into the control panel.

Normal Walk Test

Performing a 10-minute walk test to verify detection.

Microwave Walk Test

Conducting a 10-minute walk test specifically for the microwave sensor.

Anti-Mask and Troubleshooting

Anti-Mask Feature

Configuration and behavior of the anti-mask detection feature.

Troubleshooting Guide

Guidance on diagnosing and resolving common sensor issues.

Detection Patterns and Accessories

Detection Patterns

Visual diagrams showing sensor coverage areas with different lenses.

Lens Masking

Information on using lens masks to modify detection zones.

Available Accessories

List of optional accessories for the motion sensor.

Lens Change Instructions

Step-by-step guide for changing the sensor's detection lens.

Specifications and Compliance

Product Specifications

Detailed technical specifications of the motion sensor.

Approval Listings

List of certifications and standards the product complies with.

Compliance Notes

Specific notes regarding compliance with standards like EN 50131.

FCC and IC Notices

Regulatory notices from FCC and Industry Canada regarding device operation.

Related product manuals