- 1 - 
DT8320AF4 / DT8320AF5 DUAL TEC® Ceiling Mount Motion Sensor 
 
1E  
A
2E  
 
[EN] = installation agréé / instalación homologado / approved installation  
A
○
3E  
 
[A] = Trous de montage mural / Orificios de montaje fijos / Fixed mounting holes 
[B] = Fentes de montage réglables de 61 mm à 85 mm (2,4 In - 3,3 In) / Ranuras de montaje ajustables de 61 mm y 
85 mm (2,4” y 3,3”) / Adjustable mounting slots from 61mm-85mm (2.4”-3.3”) 
[C] = Trou d’autoprotection / Orificio para interruptor de seguridad / Tamper hole  
To ensure that the sensor remains within the scope of the approvals, a proper mounting of the rear housing to a 
solid surface is mandatory. It must also be ensured that the “off the wall” tamper protection contact retains its 
functionality. 
*Cet accessoire n’est pas couvert par l’agrément. / *Este accesorio está sujeto a aprobación. / *This accessory is not 
A
○
4E  
 
Exemples de câblage / Ejemplos de cableado / Wiring Examples 
Alarme, sabotage et problème/Anti
-masque 
configuré pour une boucle.
 
Alarma, sabotaje y problema/Anti
-máscara 
 
Alarm, Tamper and Trouble/Anti
-Mask 
ne loop. 
 
 
RA = Alarme EOL résistance  RF = Résistance EOL anti-masque 
RT = Tamper EOL résistance  
R1 = 1 et 2 résistance de 
connexion en boucle.
 
RA = Alarme EOL résistance  RF = Résistance EOL anti-masque 
RT = Resistencia EOL a la 
manipulación
R1 = Resistencia de conexión de 1 
y 2 bucles.
 
 = Alarm EOL resistor
 = Anti-Mask EOL resistor
RT = Tamper EOL resistor  R1 = 1 and 2 loop connection 
resistor.
 
 
Alarme, sabotage et problème/Anti
-Mask 
configurado para dois loops.
 
Alarma, sabotaje y problem
a/Anti-máscara 
configurada a dos bucles.
 
Alarm, Tamper and Trouble/Anti
-Mask 
 
 
A
○
5E