Honeywell EDA70-3 - Inserting SD Card

Chapter 1: Product Features of ScanPal Series EDA70-X Terminal
22
User Guide for ScanPal Series Terminal
Inserting SD card
You can use a SD card to expand the memory or to install software. Honeywell recommend
the using of Single Level Cell (SLC) graded SD memory card or SDHC memory card in
order to achieve optimum performance and durability.
Note: format the memory card when you use it for the first time.
1. Turn off the terminal.
2. Press down the battery cover safety button to move the lock to the unlock position at
right;
3. Open the battery cover with the battery cover buckle handle;
4. Pull out the battery (First open the battery connector side, then pull out the battery)
5. Insert the SD card;
6. Insert the battery (first insert one end before pressing the other end in order for it to be
connected to the device);
7. Press to lock the battery cover
8. Press down the battery cover and slide the battery cover buckle handle to lock it.
SD Card
Slot
9. Switch on the device