Honeywell EGPWS MK V - SECTION 3 Monitor Options

Mark V and Mark VII EGPWS Pilot’s Guide
Smart Landing
TM
060-4241-000
114 Rev H, August 2011
SECTION 3
MONITOR
Options
The options listed below are set in the RCD and setup during
the installation of Stabilized Approach Monitor, Altimeter
Monitor, and Long Landing Monitor. The flight crew cannot
configure them.
Monitor Options
:
Configurable Feature Option
Distance Unit of Measurement Feet or Metres
GPS Antenna Location
Customer-selected location based on aircraft
installation
Enable/Inhibit Discrete
Takeoff Flap and Long Landing monitors use the
same discrete as Runway Awareness
Stabilized Approach Monitor
Off or On
Voice Gender Female or Male
Enable/Inhibit Discrete
Off or On; or use the same discrete as Takeoff Flap,
Long Landing and Runway Awareness
Landing Flap Monitor Off or On
Upper Flap Gate Alert; Altitude Off or On; 500 ft. to 1400 ft., typically 950 ft.
Lower Flap Gate Alert; Altitude Off or On; 500 ft. to 1000 ft., typically 600 ft.
Excessive Approach Angle Monitor Off or On
Excessive Approach Speed Monitor Off or On; Boeing or Airbus alert curve
Altimeter Monitor
Off or On
Voice Gender Female or Male
Below Transition Altitude Enable Off or On
Above Transition Altitude Enable Off or On
Long Landing Monitor
Off or On
Voice Gender Female or Male
Configure Callout “Long Landing” or “Deep Landing”
Long Landing Distance Distance from the selected end to trigger alert
Long Landing Percentage Off or On; Percentage of runway remaining to
trigger alert
Long Landing Distance Remaining Off or On; Distance from the selected end to trigger
distance remaining alert
Long Landing Percentage Remaining Off or On; Percentage of runway remaining to
trigger distance remaining alert