CARE INSTALLATION GUIDE
11 EN1B-0478GE51 R1216
Driver Variants Depending on the firmware version there are different ways to install the USB
driver.
1. On most PC the update is done automatically with the Windows update
function.
2. Or you can use the driver delivered with CARE (procedure starts with step 7).
3. For firmware 4.00.00 or higher you can use the Microsoft driver from your
Windows 7 installation (procedure starts with step 17).
Procedure 1. Insert the A Male connector of the USB cable into an USB interface jack of the
PC and insert the B Male connector into the controller´s USB device interface
jack.
RESULT: The Found New Hardware Wizard is enabled in the Windows Task
Line.
2. In the Windows Task Line, double-click the icon.
RESULT: The Driver Software Installation message box displays.
3. If no RNDIS/Ethernet Gadget driver was found as indicated by the message ´X
No driver found`, click Change setting… button.
RESULT: The Device Installation Settings dialog box displays.
To Next Page
Loading...
