CARE INSTALLATION GUIDE
15 EN1B-0478GE51 R1216
19. Right-click on the driver in the Network adapters folder in the Device
Manager, and then click Update Driver Software.
20. Click Browse my computer for driver software
21. Click Let me Pick from a list of device drivers on my computer.
22. Uncheck the Show compatible hardware box
23. Select the Manufacturer Microsoft Corporation
24. Select Remote NDIS Compatible Device
25. Check the successful installation of the driver as described in step 5.
26. If the device status is “This device cannot start. (Code 10)”, reboot your PC.
USB Driver Installation for Windows 8
FALCON Controller
NOTE: The access to the FALCON controller via USB from a Windows 8 PC does
not need a driver installation for the D-Link DUB E100 USB adapter. A
driver installation is only necessary if you would add a further USB network
card to your PC using the D-Link DUB E100 USB adapter. If so, download
the corresponding driver from the manufacturer´s home page and install
the driver via standard procedure for Windows 7 drivers.
To Next Page
Loading...
Need help?
General
