F50F AND F300E ELECTRONIC AIR CLEANERS
9 69-0756—05
Hazardous Chemical.
Can cause personal injury.
Do not splash detergent solution in eyes.
Washing the cell(s) in a tub
• Wear rubber gloves to avoid prolonged detergent contact with your skin.
• Keep detergent and solution out of reach
of children.
NOTE: Always wash the cell(s) first, then the prefilter(s), to keep heavy prefilter lint
from getting caught in the cell(s).
1. Use a large enough container, such as a laundry tub or trash container, to hold
one or both cell(s).
NOTE: Sharp corners on the cell(s) can scratch the surface of a bathtub.
2. Dissolve about three-fourth cup of automatic dishwasher detergent per cell in
enough hot water to cover the cell(s). If the detergent does not dissolve readily,
or forms a scum on the water, try another brand, or use softened water.
3. After the detergent has completely dissolved, place the cell(s) in the container
and allow to soak for 15 to 20 minutes or until water cools. Agitate them up and
down a few times and remove. Repeat steps 2 and 3, if necessary, for very dirty
cells.
4. Next, wash the prefilter(s) the same way. Empty and rinse the wash container.
5. Rinse the cell(s) with a hard spray of very hot water; rinse the tub clean, then fill
the tub with clean hot water and soak for 5 to 15 minutes. Rinse until the water
draining from the cell(s) and prefilter(s) no longer feels slippery.
6. Soak cell(s) in a final clear water rinse for ten minutes.
7. Wipe the ionizer wires and contact board on the end of the cell using your thumb
and forefinger with a small, damp cloth.
To Next Page
Loading...
Need help?
General
