35
INSTALLER DETAILS
Name: -----------------------------------------------------------------------------------
Address: ---------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------
Telephone: ------------------------------------------------------------------------------
Office Hours: ---------------------------------------------------------------------------
Other Times: ---------------------------------------------------------------------------
Account No.: ---------------------------------------------------------------------------
APPENDIX 1 - NOTE FOR SWEDISH MARKET
Resetting Using Alarm Cause Code
This option is not normally used but, if enabled by the engineer, when a reset is required, the
user must enter an alarm cause code to reset the system.
If there are multiple alarm causes and/or multiple groups require to be reset, then the alarm
cause code only has to be entered once. The user enters the most appropriate code as deter-
mined on site. The cause code value should be determined in conjunction with the Alarm
Receiving Centre (ARC).
To Next Page
Loading...
