Need help?Do you have a question about the Honeywell Galaxy and is the answer not in the manual?
General| Brand | Honeywell |
|---|---|
| Model | Galaxy |
| Category | Security System |
| Language | English |
Allows full remote servicing of Galaxy control panels for installer use.
Software for complete remote servicing of Galaxy control panels.
Receives detailed event and alarm information from Galaxy control panels.
Connects to multiple Galaxy control panels via networks for servicing.
Services a single, locally situated Galaxy control panel.
Specifies minimum hardware and OS requirements for software installation.
Lists necessary modems, cables, and lines for remote/on-site servicing.
Instructions on launching the main shell application via shortcut or start menu.
Allows creation, modification, and management of user accounts and attributes.
Launches the Galaxy Gold application for the selected site.
Steps to launch Galaxy Gold from the Shell application.
Handles setup, dialing, and connection management.
Offers functions for copying, overwriting, logging, and programming data.
Sets up dial mode, baud rate, port, and modem name for communication.
Copies programmed data from panel to PC for viewing and modification.
Allows viewing/modification of copied data or populating a new site.
Views graphically the state of zones and outputs, and modifies controls.
Used to record data from the panel for RRI operations.
Takes and copies a baseline reading of the panel for RRI.
Transfers Galaxy Gold programming to a stand-alone RS232 module.
Steps to configure Galaxy 3-144/3-520 panels with EN50131-1 defaults.
Steps to launch the Event Monitoring application.
Assigns and modifies operator PINs for alarm actions.
Enters User PIN and remote code to log on to the panel.
To Next Page