Page 42
Non Rec Options
Time Date
When connected to a panel this will display the current time on the panel and PC and will allow you to
synchronise the panel time with that on the PC.
Bell Test
When connected to the panel this will allow you to carry out a Bell Test on the site. The duration of the bell
test can be supplied from 1-900 seconds.
There is no result data for this, the site will have to be contacted to make sure the test was successful. The
time and date and durations of the tests will be kept.
Ranges
This is the minimum and maximum acceptable values before highlighting the data as an issue. The values
are: zone resistance (ohms); RF zone signal strength (%); Voltage Range (V); Current Range (A).
RRI Reset
Resets the RRI required data in the shell to be today’s data plus the RRI interval.
Done
Exits the Remote Inspection window.
To Next Page
Loading...
