Galaxy 3 Series Programming Manual
142
3 Account No.
This is the site identifier. A unique account number must be entered, this can be up to a maximum of six digits.
The B key is used to erase an existing number. Each press deletes the last digit displayed.
4 Comms Setup
Serial communication between the on-board R232 port and a remote PC require the following 4 elements.
1 = Baud Rate
This is the number of bits that occur each second (bps). This can be set as follows:
1=300; 2=600; 3=1200; 4=2400; 5=4800; 6=9600 (default); 7=19200; 8=38400; 9=57600 .
2 = Data bits
This can be sets follows:
1=5; 2=6; 3=7; 4=8 (default)
3 = Stop Bits
This can be set as follows:
1=1 (default); 2=2.
4 = Parity
This can be set with one of three options:
1 = No Parity (default)
2 = Odd Parity
3 = Even Parity
56 - Communications (cont’d)
To Next Page
Loading...
