15. The pull chain extension or custom pull chain
extension (sold separately) may be attached to fan
pull chains (Fig. 15).
Fig. 15
Fan
Pull Chain
Fan Pull Chain
10
FINAL INSTALLATION
Screw Washer
14. Remove the three screws and washers from the
upper switch housing. Connect plug from the motor
to the plug from the switch housing cap. Align holes
in the switch housing cap with holes in upper switch
housing. Re-install screws and washers that were
previously removed. Use a Phillips screwdriver (not
included) to secure all screws (Fig. 15).
Switch
Housing
Cap
Screw
and
Washer
Fig. 14
To Next Page
Loading...
