Xenon/Granit User Guide 337
The bar code is displayed on the host device correctly, but you still have to press a
key to enter it (the Enter/Return key or the Tab key, for example).
• You need to program a suffix. Programming a suffix enables the scanner to
output the bar code data plus the key you need (such as “CR”) to enter the data
into your application. Refer to Prefix/Suffix Overview on page 161 for further
information.
The scanner won’t read your bar code at all.
• Scan the sample bar codes in the back of this manual. If the scanner reads the
sample bar codes, check that your bar code is readable.
• Verify that your bar code symbology is enabled (see Chapter 10).
• If the scanner still can’t read the sample bar codes, scan All Symbologies on
page 188.
To Next Page
Loading...
