Honeywell Granit XP 1990iSR - Dotcode

190 Granit XP User Guide
DotCode
< Default All DotCode Settings >
DotCode On/Off
Poor Quality DotCodes
This setting improves the scanner’s ability to read damaged or badly printed Dot-
Codes. Default = Poor Quality DotCodes Off.
DotCode Message Length
Scan the barcodes below to change the message length. Refer to Message Length
Description (page 142) for additional information. Minimum and Maximum
lengths = 1-2400. Minimum Default = 1, Maximum Default = 2400.
On
* Off
Poor Quality DotCodes On
* Poor Quality DotCodes Off
Minimum Message Length
Maximum Message Length