Honeywell Granit XP 1990iSR - Page 270

252 Granit XP User Guide
GS1-128 Default All GS1-128 Settings GS1DFT 159
*On GS1ENA1 159
Off GS1ENA0 159
GS1-128 Message Length Minimum (1 - 80) *1 GS1MIN## 159
Maximum (0 - 80) *80 GS1MAX## 159
Telepen Default All Telepen
Settings
TELDFT 160
*Off TELENA0 160
On TELENA1 160
Telepen Output *AIM Telepen Output TELOLD0 160
Original Telepen Output TELOLD1 160
Telepen Message Length Minimum (1 - 60) *1 TELMIN## 160
Maximum (1 - 60) *60 TELMAX## 160
UPC-A Default All
UPC-A Settings
UPADFT 161
Off UPBENA0 161
*On UPBENA1 161
UPC-A Check Digit Off UPACKX0 161
*On UPACKX1 161
UPC-A Number System Off UPANSX0 162
*On UPANSX1 162
UPC-A 2 Digit Addenda *Off UPAAD20 162
On UPAAD21 162
UPC-A 5 Digit Addenda *Off UPAAD50 162
On UPAAD51 162
UPC-A Addenda Required *Not Required UPAARQ0 162
Required UPAARQ1 162
Addenda Timeout Range (0 - 120) *500 DLYADD##### 163
UPC-A Addenda
Separator
Off UPAADS0 163
*On UPAADS1 163
UPC-A/EAN-13 with Extended
Coupon Code
*Off CPNENA0 163
Allow Concatenation CPNENA1 163
Require Concatenation CPNENA2 163
Addenda Timeout Range (0 - 120) *500 DLYADD##### 164
Coupon GS1 DataBar Output *GS1 Output Off CPNGS10 164
GS1 Output On CPNGS11 164
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page