Rev 1.01 5 Document 900.0275
10/05
Figure 4 Gimbal Adjustment
Adjusting the Lens Focus
Lenses are pre-focused at the factory but may require a final adjustment after
installation in the unlikely event the optical effect of the dome causes a slight
defocusing of the lens.
TECH TIP! To check the focus, hold the dome over the lens while making
any adjustments.
To adjust the camera direction, view angle and focus, connect the service
monitor cable (supplied) to the video monitor output.
Tilt
Pan
Horizontal rotation
3
1
2
3
1
2
Legend
1 = Pan rotation
2 = Horizontal rotation
3 = Tilt rotation
To Next Page
Loading...
