Need help?Do you have a question about the Honeywell HDZ302DE and is the answer not in the manual?
General| Series | HDZ |
|---|---|
| Image Sensor | 1/2.8" Progressive Scan CMOS |
| Scanning System | Progressive |
| IR On/Off Control | Auto/Manual |
| IR LEDs | 6 |
| Focus Control | Auto/Manual |
| Gain Control | Auto/Manual |
| Digital Zoom | 16x |
| Streaming Method | Unicast/Multicast |
| Certifications | CE, FCC, UL |
| Ingress Protection | IP66 |
| Vandal Resistance | IK10 |
| Night Vision | Yes |
| Two-Way Audio | Yes |
| Weather Resistance | Yes |
| Effective Pixels | 1920 (H) x 1080 (V) |
| Electronic Shutter Speed | 1/1 s to 1/30, 000 s |
| Minimum Illumination | 0 Lux with IR |
| Power-off Memory | Yes |
| Protocol | HTTP, HTTPS, DHCP, DNS, DDNS, RTP, RTSP, PPPoE, SMTP, NTP, UPnP, SNMP, 802.1x, Qos |
| Video Compression | H.264 |
| Streaming Capability | Triple-streaming |
| Resolution | 1920 x 1080 |
| Bit Rate Control | CBR / VBR |
| Day/Night | Auto (ICR), Color, B/W |
| BLC Mode | BLC/HLC/WDR |
| White Balance | Auto / Manual / Outdoor / Indoor / Sodium Lamp |
| Noise Reduction | 3D DNR |
| Motion Detection | Support |
| Region of Interest | 4 zones |
| Electronic Image Stabilization (EIS) | Yes |
| Defog | Yes |
| Flip | Yes |
| Privacy Masking | 4 zones |
| Audio Compression | G.711 |
| Network | 10/100Base-T Ethernet |
| Interoperability | ONVIF Profile S, PSIA, CGI |
| Edge Storage | Micro SD card |
| Web Viewer | IE, Chrome, Firefox, Safari |
| Smart Phone | iOS, Android |
| Power Supply | DC12V / PoE |
| Power Source | 24 VAC & PoE+ (802.3at) |
| Storage | Micro SD card |
| Connectivity | 10/100Base-T Ethernet |
| Bit Rate | 32 Kbps to 16384 Kbps |
Install the IPC Tool utility on your PC to manage camera discovery and setup.
Use the IPC Tool utility to locate and connect to cameras on the network.
Configure static or dynamic IP addresses for single or multiple cameras.
Install the latest firmware to ensure optimal performance and security.
Connect to the camera's web interface via a browser for live viewing and control.
Access the camera's web interface using default or custom credentials.
Set up video compression formats, resolution, frame rate, and bit rate for streams.
To Next Page
