www.honeywell.com/security
48 | Performance Series HQA Digital Video Recorder Remote User Guide
Figure 3-14 Mobile Setup Configuration Interface
Activate/deactivate 3G/4G connected phones or mobile phones, or the phone you configured
to get alarm messages.
Configuring PPPoE
1. Click PPPoE in the Network configuration interface to open the PPPoE configuration
interface.
Figure 3-15 PPPoE Configuration Interface
2. Enter the PPPoE User Name and Password, which you receive from your Internet
Service Provider (ISP).
3. Click Save to save the changes.
4. Reboot the device to activate these changes.
After rebooting, the device should connect to the Internet through the PPPoE connection.
The IP address is found in the WAN from the IP address column.
To Next Page
Loading...
