Honeywell HRHT41612 - Page 74

www.honeywell.com/security
74 | Performance Series HQA Digital Video Recorder Remote User Guide
PTZ Activation When PTZ activation is configured, the system can activate
PTZ operation when an alarm is detected.
1. Click Setup to open the PTZ Activation configuration
interface.
2. Select a preset, tour, or pattern from the drop-down menu.
3. Click Save.
Tour Click to enable a tour to be triggered by an alarm. The system
supports 1/8-window tour. See Configuring Display Settings
on page 88 for tour interval setup. On the Display Settings
tab, when there are two tours enabled by default, you can
configure the system so an alarm triggers the system to
enable the alarm tours you configured here. If there is no
alarm, then the system uses the tour setup that was
configured in the Display interface.
Snapshot Click to enable the Snapshot function. Channel snapshots
are taken according to the schedule you configure. Alarm
snapshots are taken when an alarm occurs.
Video Matrix
Click to enable. When an alarm occurs, the SPOT OUT port video
(a 1-window tour) from the alarm activation channel selected in
the Record Channel.
Voice Prompts Select to enable audio broadcast/voice prompts in response to
the event you selected in the drop-down list of event types.
File Name Select a file for the voice prompt.
Show Message Click to enable a pop-up message on your local host PC
screen to let you know an alarm has occurred.
Send Email The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to Main
Menu
SettingNetworkEmail to configure the email
settings. See Configuring Email on page 53.
Buzzer Click to enable the Buzzer function. When an alarm occurs,
the buzzer beeps.
Message Enable to send a message to the device which supported the
3G/4G module when the event triggers.
Log Click to enable the DVR to record a local alarm log.
Table 3-15 Remote Alarm Configurations
Configuration Description