Honeywell HWB1033S - Loading the Water Bottle; Loading Bottles with Spill-Proof Cap

10
WARNING: Only use 3 or 5 gallon water bottles on this
water cooler.
WARNING: Please make sure to turn OFF the unit when
the hot and cold water tanks are empty. Always have water
inside the tanks before turning ON any switch.
Loading bottles with spill proof cap
• Thisunitcontainsafunnelwithaprongtoavoidspills
when using bottles with spill proof cap.
• Carefullyliftthebottle(approx.40lbs.forthe5gallon
bottle). Bend your knees to lift the bottle, not your back.
Do not place hands over the opening of the bottle while
placing it on the unit. Please seek help if you are unable
to lift the water bottle.
• Invertthe3or5gallonwaterbottleovertheunitand
gently let the neck of the bottle slide into the funnel,
making sure the spill proof cap slides down into the
prong.
• Theprongwillbreakthespillproof capallowing the
water from the bottle to go down into the funnel and
into the main reservoir without any spills.
• Allow the water to ll all tanks of the unit for
approximately one minute.
• Pushinonallwaterleverstomakesurewaterows
from all faucets.
• Plugtheunitbackintotheelectricaloutlet.
• TurnONthehotwaterswitch,waitacoupleofminutes
and turn ON the cold water switch. Allow the unit to
reach the minimum cold and hot water temperatures.
This will take approximately 45 minutes and the
indicator lights will turn OFF.
• Testthewatertemperaturesbypushingonceagainon
the water levers.
• Yourwatercoolerisnowreadyforuse.
5G
3G
8. INSTRUCTIONS FOR LOADING THE WATER BOTTLE