68 CV41 Vehicle Mount Computer (Windows CE) User Guide
Enable Screen Blanking
After you have wired and mounted the motion switch sensor, you must enable screen
blanking in Intermec settings on the vehicle mount computer.
1. In Intermec Settings, select Device Settings > Screen Blanking on Motion.
2. In Screen Blanking on Motion, select the COM port the custom serial cable is
connected to.
3. In Screen-on delay after motion stops (sec), enter the amount of time in seconds
that you want the display to turn on after the vehicle is stationary.
4. Tap OK. Screen blanking is enabled.
To Next Page