Honeywell IPCAM-WIC2 User Manual (English)

To Next Page

Google Play and the Google Play logo are trademarks of Google Inc.

IPCAM-WIC2 HD Wi-Fi Indoor Video Camera

Quick Installation Guide

IPCAM-WIC2 is a 1080p, full HD Wi-Fi video camera intended for indoor use with Honeywell Total Connect® 2.0.

Low-light operation is indicated by four red LEDs located on the front of the camera, arranged around the lens.

Camera setup requires a Total Connect® 2.0 account and the new Total Connect 2.0 mobile app. Video Services must

be enabled in AlarmNet 360™. Camera operation requires minimum available bandwidth of 2.1 Mbps.

For best results, set up only one camera at a time.

Download the Total Connect® 2.0 app from the App Store or on Google Play.

(Look for the red Total Connect logo.)

a. Turn on your smart device’s Bluetooth and Wi-Fi. [Make

sure the Bluetooth isn’t connected to another device and that

you’re on the same Wi-Fi network your camera(s) will use .]

b. Launch the app and sign in with your Total Connect® 2.0

account.

c. Plug the power supply into an AC outlet, but:.

Don’t connect the power supply to the camera yet.

Note that the screens in your app may be a bit different than the

examples seen here.

If your account has more than one Location, select the one where

you’re doing camera setup.

You may have to press CAMERAS at the bottom of the screen to see

the Cameras page.

a. Press ADD CAMERA

b. Select the type of camera you’re installing.

c. Name the camera and press NEXT.

d. Connect the power supply to the camera. The LED at the top flashes

a variety of colors. After about a minute, the camera sounds a tone.

Then, WAIT for the camera’s LED to flash blue only.

e. Press NEXT on the app.

a. On the Pair Your Camera screen, press Generate QR Code. After

a brief wait, the code appears.

b. Show the QR code on your device to the camera from 3 – 8 inches

away. You will be notified when the code has been successfully

scanned.

c. Select your security system’s Wi-Fi network and press NEXT.

d. Enter the network password and press NEXT. Final setup begins.

When the app displays Setup Successful, the process is complete*.

Press DONE or ADD ANOTHER CAMERA.

After setup, go back to the CAMERAS page and check your

newly-registered camera.

Touch the preview image to launch a live stream from the camera.

*The app will tell you if you need to repeat the setup process. This

involves resetting the camera, which is described in the

app itself.

See the other side of this sheet for more information about the

required steps.

Need help?

Do you have a question about the Honeywell IPCAM-WIC2 and is the answer not in the manual?

Honeywell IPCAM-WIC2 Specifications

General

Model	IPCAM-WIC2
Category	IP Camera
Manufacturer	Honeywell
Image Sensor	CMOS
Lens	3.6mm
Night Vision	Yes, up to 33 feet
Connectivity	Wi-Fi (IEEE 802.11 b/g/n)
Operating Temperature	-10°C to 50°C
Supported Protocols	TCP/IP, HTTP, DHCP, DNS, RTSP
Audio	Two-way audio
Storage	MicroSD card slot