To Next PageTo Next Page
Need help?Do you have a question about the Honeywell HBW2PR1 and is the answer not in the manual?
General| Resolution | 1920x1080 (1080p Full HD) |
|---|---|
| IR Distance | Up to 30 m (98 ft) |
| Night Vision | Yes |
| Video Compression | H.264 |
| Power | PoE (802.3af) or 12 VDC |
| Weather Resistance | Yes |
| Power Supply | 12 VDC or PoE (Power Supply not included) |
| Connectivity | RJ45 |
| Motion Detection | Yes |
| Image Sensor | 1/2.7" progressive scan CMOS |
Instructions for installing the Honeywell Config Tool IP utility on your PC for camera management.
Steps to assign a new static IP address to a camera device using Config Tool.
Procedure for upgrading the camera's firmware using the Config Tool software.
Steps to log in to the camera using its web client for monitoring and configuration.
Description of the Live View interface areas and controls for monitoring.
Description of the controls used for playing back recorded video.
Adjusts camera properties like brightness, contrast, saturation, and sharpness.
Settings for video compression, resolution, frame rate, and bit rate.
Configure static or DHCP IP settings, DNS servers, and network protocols.
Manage recording schedules, snapshot schedules, and holidays.
Setup and management of user accounts, groups, and their permissions.
Procedure for upgrading the camera's firmware through the system interface.
Enable and configure motion detection parameters like area, sensitivity, and delay.
Set up alarm types, operations, and alarm tone settings.
Solutions for issues preventing playback of downloaded video files.
Troubleshooting steps for failed firmware upgrades over the network.
