To Next PageTo Next Page
Need help?Do you have a question about the Honeywell HBW4PR1 and is the answer not in the manual?
General| IR Distance | Up to 30 m |
|---|---|
| Day/Night | IR cut filter with auto switch |
| IP Rating | IP67 |
| Protection | IK10 |
| Operating Temperature | -30°C to 60°C (-22°F to 140°F) |
| Resolution | 2688 × 1520 |
| Lens | 2.8 mm |
| Video Compression | H.265/H.264 |
| Power | 12V DC, PoE (802.3af) |
| Power Supply | 12 VDC |
| Image Sensor | 1/2.8" CMOS |
| Field of View | Horizontal: 102°, Vertical: 56° |
Guides on installing the Config Tool IP utility for camera setup.
Explains how to use Config Tool to find IP devices on the network.
Steps to log in to the camera using its web client interface.
Configuring video bit stream settings for main and sub streams.
Adjusting video compression, frame rate, bit rate, and other stream parameters.
Setting up network parameters like TCP/IP, PPPoE, DDNS, and IP Filter.
Configuring IP address, subnet mask, gateway, DNS, and other TCP/IP settings.
Setting up recording schedules, holidays, and storage destinations.
Adding or removing schedules for recording and snapshots with color codes.
Setting up general system parameters, date/time, account, and defaults.
Setting up motion detection parameters like area, sensitivity, and record delay.
Enabling and configuring camera tampering detection functions.
Configuring alerts for system events like SD card errors and disconnections.
