Honeywell IR8M - User Manual

- 1 -
2.3 m - 2.7 m
(7.5 ft - 9 ft)
Corner mount
Montage en angle
Montaje en esquina
Montaggio ad angolo
Hoeksteun
Eckmontage-Halterung
7 mm
(0.28”)
6 mm
(0.25”)
PCB
A
BB
1 2 3
IM
w
IRPI8M
IR8M
IM
w
IR(PI)8M - Installation Instructions
Passive Infrared Wireless Detector









Tamper
A
uto protection
Seguridad
Dispositivo
antimano-
missione
Sabotage
schakelaar
Sabotage-
kontakt
DIP switch
Switches
Interruptor DIP
Interruttore DIP
DIP-schakelaar
DIP-Schalter
Wall mount
Montage mural
Montaje en pared
Montaggio a muro
Wandsteun
Wandmontage-
Halterung
Sensor base
Embase
Base del sensor
Base del sensore
Grondplaat van de
sensor
Gehäuseunterteil
Wall
Mur
Pared
Parete
Wand
Wand
Sensor base
Embase
Base del sensor
Base del sensore
Basis van de sensor
Gehäuseunterteil
Tamper switch
Poussoir d'auto protection
Interruptor contra
manipulación
Interruttore
antimanomissione
Sabotage-
schakelaar
Sabotagekontakt
Tamper lever
Poussoir de l'AP
Palanca de seguridad
Leva
antimanomissione
Sabotage-schakelaar
Sabotagehebel
Use an M4 or M5 (#8 or #10) screw
Utiliser une vis M4 ou M5
Utilice un tornillo M4 o M5 (nº 8 o nº 10)
Utilizzare una vite M4 o M5 (8 o 10)
Gebruik een M4 of een M5 (#8 of #10) schroef
Verwenden Sie eine M4- oder M5-Schraube

Honeywell IR8M Specifications

General

Brand	Honeywell
Model	IR8M
Category	Accessories
Language	English

Summary

Introduction

Tamper Protection

Mounting Location

Mounting

Quick Install (with Wall Mount)

Step-by-step guide for mounting the device using the wall mount without opening it.

EN50131;NF&A2 P Conformity

Rules for installation to comply with EN50131-2-2 and NF&A2P standards, including height and mounting.

LED Operation

Device Configuration

DIP Switch Settings

Configure radio protocol and detection sensitivity using internal DIP switches.

Power Up

Registering the Sensor

Walk-Test Mode

Battery Replacement